With a robust thru-shaft design and heat treated, cast-alloy steel for durability, our fluted reamers get the job done for you

With aggressive cutting and mixing design characteristics, this reamer is designed to help reduce pullback and rotational forces required from the drill rig.

Take a bite out of tough conditions. Ruggedly constructed with work-hardened, high-alloy steel, this reamer incorporates a unique, steep, rear-tapered design for ease of push back when needed. Optional built-in swivel or thru-shaft designs are also available. High-wear areas are made to last with a resilient carbide mesh grit hard facing. Equipped with oversized Shark Teeth tooling for aggressive, yet smooth, cutting action, the T-Rex is ready for cobble, chunk rock and soft rock.

The 2.375" API Armor System is compatible with D16x20 - D50x100

Assembly includes Gauntlet bit, two sets of medium formation teeth, one retention pin, two o-rings and two cap screws. Designed for use in soft to medium rock, shale and caliche ground conditions up to 10,000 psi (344.7 bar) with exceptional steering capabilities. Carbide buttons are strategically placed on the bit for optimum cutting, and carbide hard facing helps to enhance wear and performance characteristics. A replaceable three-tooth design delivers a consistent cutting structure for steering corrections and maximum drilling performance.

Featuring a universal design, the Double Eye swivel can be used with any reamer that doesn’t include a built-in swivel.

Vermeer provides Ditch Witch® compatible adapters to meet your needs with high alloy steel and finished  with a 100% thread inspection process.

Vermeer offers a range of thread lube, designed for all seasonal applications and various HDD models, including the environmentally friendly BioStick.

The long-range DigiTrak F5 Fluid Pressure Transmitter (Model FPT) provides downhole fluid pressure monitoring up to 250 psi (1725 kPa). The drilling fluid pressure is measured through sensor ports located on the front end cap on either side of the index slot. The FPT is available in two dual-frequency configurations:  19.2 kHz/12 kHz and 12 kHz/1.3 kHz.  These transmitters have light-green tubes and incorporate a new mechanical design, in addition to the fluid pressure sensors.  The new design has a knurled battery cap that is not flush with the battery compartment, as the older version was.  With the cap installed, the overall length is still 15 in. (38.1 cm), but without the cap the length is 14.6 in. (37.08 cm).  Thus, the FPT transmitters are compatible with existing drill housings that accommodate 15 in. (38.1 cm) DigiTrak transmitters.  If using a tooling adapter, however, the new design will require a different adapter.  Also, the housings must allow fluid to flow to the sensor ports for measurement of the drilling fluid pressure.

The Vermeer universal side load transmitter housing is compatible with 15” (38.1 cm) and 19” (48.3 cm) transmitters (all acceptable for wireline). It also carries a replaceable rear sub and threaded front for virtually limitless adaptability, including the Armor™ Drilling System and mud motors. The versatility of this tool also qualifies it for a range of projects, from standard bores to sensitive on-grade sewer work.

The Premium Dirt Extended Housings is a variation of the Premium Dirt Housing from Vermeer which integrates many of the robust and proven design characteristics of the rock-focused Armor drilling system into a versatile tool for soft to intermediate ground conditions, but is made to accept both the 15” and 19” transmitters from DCI®.

Use Vermeer rod wipers to keep your drill rods clean, designed to the exacting specifications of Vermeer horizontal directional drills.